Click on images to see them in full screen
System Requirements
smsPULSE for Windows - System Requirements
- Windows Server 2003 and upwards - fully patched, 32 bit or 64 bit OSs
- Permanent Internet connection (for HTTPS-only installation), either directly or via proxy (see Proxy configuration page
)
- Compatible GSM device (for MM installation or GSM-only installation)
You do NOT need any modems to use smsPULSE Standard edition.
smsPULSE for Domino - System Requirements
- 32 bit - Domino 7.0.3 and upwards server
- 64 bit - Domino 8.0.2 and upwards server
- Permanent Internet connection (for HTTPS-only installation), either directly or via proxy (see Proxy configuration page )
- Compatible GSM device (for MM installation or GSM-only installation)
- OSs: Windows 2003 Server and above
You do NOT need any modems to use smsPULSE Standard edition.
OMS
If you wish to use the smsPULSE OMS service (Microsoft Outlook Mobile Service), you will also need an SSL Certificate. See here .
Supported GSM Devices
You will need to connect your GSM device through a COM port, normally using a serial cable. If you have USB devices these normally come with USB-to-COM device drivers. Hand held cell phones may work, but rarely for inbound text (they do not "inform" our software). You may also use TAPI devices from Version 4.
Recommended devices are:
Siemens TC35i, MC35
Siemens TC65
Please note that we sell complete modem bundles at near cost price to smsPULSE clients only.
MMS
To send MMS messages your device must be able to support GPRS. For better speed, a 3G device is recommended.
New device types
Falcom SAMBA 75 Quad Band GSM/GPRS USB Modem - designed for use on any GSM network in the world;
MultiTech GSM Modem model MTCBA-G-UF1 - USB port only; 900/1800 MHz (Europe);
MultiTech GSM Modem model MTCBA-G-UF2 - USB port only; 850/1900 MHz (North-America);
WaveCom Fastrack Supreme - Serial and USB; 850/900/1800/1900 MHz.
And others
Inbound SMS/MMS not receiving
If your device fails to accept incoming SMS, please perform the following steps:
- Exit the smsPULSE GSM Setup application
- Connect to your GSM device using a program like HyperTerminal (for Windows Vista you will have to find a download)
- Ensure the speed of the device is set to 115200 for Siemens TC65, or similar
- Once you connect to the device, send the following commands:
To see what you type, issue the following AT command:
ATE1
Then...
AT+CPMS="SM","SM","SM"
After the response, type this command...
AT+CPMS="MT","MT","MT"
From V8 you should not need to perform the settings if you use the new smsLINES MMS service, including when forcing the service when not using MMS